|
Communication protocol
|
UDP must be supported.
|
|
Communication port
|
SNMP command
|
Must be able to send a Get request to destination port 161.
|
|
SNMP trap
|
Must be able to receive a packet destined for port 162.
|
|
SNMP version
|
v2c must be supported.
|
|
Setting a source IP address for a trap to be received
|
-
(Virtual machine)(Bare metal)
In the event log SNMP transfer settings, the
source IP address is as follows:
-
If the representative IP address of the
storage cluster is not set:
Control network IP address of the
cluster master node (primary)
-
If the representative IP address of the
storage cluster is set:
Representative IP address of the storage
cluster or control network IP address of the cluster
master node (primary)
The cluster master node (primary) might
be changed to another storage node due to storage node
failure or other reasons. To ensure that traps can be
received even in such cases, when registering a source IP
address, set the representative IP address of the storage
cluster and the IP addresses of all storage nodes for the
control network.
-
(Cloud)
SNMP transfers from VSP One SDS Block do not pass through the load
balancer, so the source IP address remains the IP address of
each storage node for the control network. Therefore, when
you register a source IP address, specify the IP address of
each cluster master node for the control network, not the IP
address assigned to the load balancer.
|