Step 5: Power on the storage system

Storage system installation (without SVP)

Version
88-08-0x
88-07-0x
88-06-0x
Audience
anonymous
Part Number
MK-97HM85020-00

  1. Power on the PDUs.
  2. Confirm that the top (POWER) LED on the lower left front side of the controller is lit amber, as shown in the following figure. If the storage system has a drive tray, confirm that the POWER LED on the lower left front side of the drive tray is lit green.


    Item Description
    1 POWER LED on the front of the controller
  3. If the front bezels are not attached to the front of the controller and drive tray, attach them as follows:
    1. Line up the two tabs on the left side of the controller or drive tray with the two slots on the left side of the bezel.
    2. Connect the bezel by sliding it on and swinging the bezel closed.
    3. Use the key to secure the bezel to the front of the unit.


    Item Description
    1 Bezel slots
    2 Tabs
    3 Key
  4. On the lower left front side of the controller, press and hold the POWER ON/OFF button until the POWER LED changes to green (about 3 seconds), and then release the button.


    Item Description
    1 Controller (front bezel attached)
    2 Controller (front bezel removed)
    3 READY LED on controller (front bezel removed)
    4 POWER LED on controller (front bezel removed)
    5 READY LED on controller (front bezel attached)
    6 POWER LED on controller (front bezel attached)
  5. Wait for the green READY LED on the front of the controller to go on (approximately 16-25 minutes).
    Note: If the READY LED does not go on after 30 minutes, contact customer support.