Step 4: Installing the drive boxes into the rack

Drive boxes must be installed using a rack rail at specific locations on the rack depending on the rack layout.

1. Pull down the clips on the front and rear of the rail.
2. Fit the positioning pins into the position holes on the right side of the rack.
3. Replace the clips to the upright position to hold the rail in place.
   
   

   

   
   

   Number	Item
   1	Pin
   2	Clip

4. Fix the loop cable tie with the rail screw and fix into position on the rear of the rack.
   
   

   

   
   

   Number	Item
   1	Clip
   2	Cable tie
   3	Screw

5. Repeat Steps 1-4 on the left side of the rack.
6. Install the drive box to the rail using the drive box bracket.
7. Fasten the bracket and drive box to the rail using two screws on each side of the rack.
   
   

   

   
   

   Number	Item
   1	Bracket
   2	Screws
   3	Clip

8. Attach the side bezel to the left and right sides of the rack by sliding the bezels in place.