Syslog settings

System Administrator Guide for Virtual Storage Platform E Series

Version

93-07-0x

Audience

anonymous

Part Number

MK-97HM85028-18

For details about the format of alert notifications sent to the syslog server, see Syslog message.

You must have the Storage Administrator (View Only) or Storage Administrator (Initial Configuration) role to perform this task.

Click the Syslog tab.
Select the type of transfer protocol to use.
In Primary Server:
1. Click Enable to use the server or Disable not to use it.
2. Select the type of IP address to use for the server: IPv4 or IPv6.
3. In Client Certificate File Name, click Browse to select a client certificate file.
In Secondary Server:
1. Click Enable to use the server or Disable not to use it.
2. Select the type of IP address to use for the server: IPv4 or IPv6.
3. In Client Certificate File Name, click Browse to select a client certificate file.
In Location Identification Name, enter a name to use to identify the server.
To set up an automatic attempt to reconnect to the server in case of communication failure, in Retry, click Enable. Click Disable to not use this feature.
If you enabled retry, in Retry Interval, enter the number of seconds that the system will wait between retry attempts.

Note: If SIMs are not transferred to the Syslog server, verify the settings in the procedure. If all settings are correct, verify the settings and operating conditions of the Syslog server itself, and the operating conditions of the Management LAN.