Use the following procedure to set up a syslog server for your storage system.
CAUTION:
If you specify the IP address of the syslog server in IPv6 address format, do not use the following IP addresses:
- Invalid value: [::]
- Loopback address: [::1]
- Multicast address: [FF00:: - FDFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF]
- IPv4-mapped IPv6 address: [::FFFF:(IPv4)]
- Link-local address: [FE80::]
- Global unicast address: [2001::]
- Global unicast address: [2002::]
- You must have the Audit Log Administrator (View & Modify) role to perform this task.
- In the maintenance utility, expand the Administration tree, and then select Audit Log Settings.
- Click Set Up Syslog Server.
- In the Set Up Syslog Server for Audit Logs window:
- Select the desired Transfer Protocol.
- Enable or disable the Primary Server.
- Enable or disable the Secondary Server.
- Enter the Location Identification Name.
- Enable or disable the Retry. If enabled, enter the desired retry interval.
- Enable or disable the Output Detailed Information.
- When are finished specifying the syslog server settings, click Apply to save the settings and close the window.