Step 8: Power on the storage system

Virtual Storage Platform E1090 Installation Guide

Version
93-07-2x
93-07-0x
93-06-8x
Audience
anonymous
Part Number
MK-97HM85053-01

After connecting the management console to the storage system, you can power on the storage system.

  1. Power on the PDUs.
  2. Confirm that the top (POWER) LED on the lower left front side of the controller is lit amber, as shown in the following figure. If the storage system has a drive tray, confirm that the POWER LED on the lower left front side of the drive tray is lit green.
  3. If the front bezel is not attached to the front of the controller, attach it as follows:
    1. Line up the two tabs on the left side of the controller with the two slots on the left side of the bezel.
    2. Connect the bezel by sliding it on and swinging the bezel closed.
    3. Use the key to secure the bezel to the front of the unit.
  4. On the lower left front side of the controller, press and hold the POWER ON/OFF button until the POWER LED changes to green (about 3 seconds), and then release the button.
  5. Wait for the green READY LED on the front of the controller to go on (approximately 13 minutes).
    Note: If the READY LED does not go on after 30 minutes, contact customer support.