Configuring remote paths

Storage Advisor Embedded User Guide

Version
93-07-2x
88-08-12
Audience
anonymous
Part Number
MK-97HM85022-25

You can configure remote paths between the two storage systems that are required for a global-active device environment. Because a remote path is required to send data to the connection-destination storage system, you must configure remote paths for both storage systems so they can send data to each other.

  • Connect physical paths between the two storage systems that make up the global-active device environment.
  • Identify the following:
    • Model and serial number of the connection-destination storage system
    • ID of the path group
    • Port to use on the connection-source storage system and the port of the connection-destination storage system
    • IP address and TCP port number of the connection-destination storage system (when using iSCSI for the protocol)
  1. In the navigation bar, click Others > Remote Path Groups.
  2. Click the plus sign (+).

  3. Specify the required items, and then configure the remote path.
  4. Click the ID of the path group to open the details page. Make sure that the status of the remote path you configured is Normal.
    Note:

    If the status of the remote path is not Normal, see the Global-Active Device User Guide.