Enabling HSTS

System Administrator Guide for VSP E990 and VSP G130, G/F350, G/F370, G/F700, G/F900

Part Number

To enable HSTS, use the following procedure:
  1. Open a command prompt with administrator permissions on the SVP.
  2. Move the current directory to the folder in which the setting tool is located, and then execute the following command:
    cd /d C:\Mapp\wk\Supervisor\MappIniSet
    Note: C:\Mapp: Indicates the installation directory of storage management software and SVP software. If you specified an installation directory other than C:\Mapp, replace C:\Mapp with the specified installation directory.
  3. When "Press any key to continue ..." appears in the window, press the Enter key.
  4. To verify that HSTS is enabled, execute the following command:

    If "hsts=on" appears, HSTS is enabled. Press the Enter key. If "hsts=off" appears, HSTS is not enabled. Press the Enter key, and then go back to step 2.

    If the message indicating that the specified file could not be found appears, the HSTS settings failed. Press the Enter key, and then go back to step 2.

  5. Close the command prompt window.