SMI-S provider startup setting

System Administrator Guide for VSP E990 and VSP G130, G/F350, G/F370, G/F700, G/F900
Version
88-06-0x
Audience
anonymous
Part Number
MK-97HM85028-08
You can enable or disable the service by performing the SMI-S provider startup setting.
Note: If the service is set to disable by the startup setting, the SMI-S function cannot be used because the service does not start.
  • The SVP software version is 88-03-01-xx/00 or later.
  • SMI-S provider service has been stopped.
  1. On the SVP, start Windows command prompt as an Administrator.
  2. Execute the following command: 
    C:\Mapp\wk\Supervisor\SMI\SetServiceStartupType.bat Serial-number-of-storage-system Startup-type

    Specify enable or disable for Startup-type.

    Note: C:\MAPP indicates the installation directory of the storage management software and the SVP software. When the installation directory other than C:\Mapp was specified, replace C:\Mapp with the specified installation directory.
  3. The completion message appears. Press any key to continue.
  4. Close the command prompt.
    Note: The startup setting is reflected after starting the service in each storage system next time.