Change Sending Trap Setting window (SNMP v3)

System Administrator Guide for VSP E990 and VSP G130, G/F350, G/F370, G/F700, G/F900

Version: 88-06-0x
Audience: anonymous
Part Number: MK-97HM85028-08

This window appears when you click Change on the SNMP tab of the Set Up Alert Notifications window if the SNMP protocol version is SNMP v3.

Item	Description
Send Trap to	Specify the IP address to which SNMP traps are reported. IPv4: Enter a valid IPv4 address in the format `XXX`.`XXX`.`XXX`.XXX (where `XXX` is a number from 0 to 255) IPv6: Enter a valid IPv6 address in the format `YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`: (where `YYYY` is a hexadecimal number from 0 to FFFF). You can also use an IPv6 address in abbreviated format.
User Name	Enter the user name to be used for reporting SNMP traps. You can enter up to 32 alphanumeric characters, excluding the following symbols: \ , / ; : * ? " < > \| & % ^ Do not enter space characters at the beginning or the end of the value. Note: If you use a user name that has already been specified for Sending Trap Setting or Request Authentication Setting, specify the same settings for the following options that were specified for that name. Otherwise, SNMP traps might not be sent correctly. Authentication Authentication - Protocol Authentication - Password Encryption Encryption - Protocol Encryption - Key
Authentication	Select whether to perform the authentication. Enable: Authentication is performed. Disable: Authentication is not performed. Authentication and encryption information is displayed only if authentication is enabled.
Authentication - Protocol	If authentication is enabled, select the authentication method. SHA MD5
Authentication - Change Password	Select to display the Password field and change the password. If you are enabling authentication, this selection cannot be cleared.
Authentication - Password	If authentication is enabled, enter a password. The password must be 8 to 64 alphanumeric characters, excluding the following symbols: \ , / ; : * ? " < > \| & % ^ Do not enter space characters at the beginning or the end of the value.
Encryption	Select whether or not to perform the encryption Enable: Encryption is performed. Disable: Encryption is not performed. Encryption information is displayed only if encryption is enabled.
Encryption - Protocol	If encryption is enabled, select the encryption method. AES DES
Encryption - Change Key	Select to display the Key field and change the key. If you are enabling authentication, this selection cannot be cleared.
Encryption - Key	If encryption is enabled, enter a key. The key must be 8 to 64 alphanumeric characters, excluding the following symbols: \ , / ; : * ? " < > \| & % ^ Do not enter space characters at the beginning or the end of the value.
Encryption - Re-enter Key	Re-enter the same key.