Add Sending Trap Setting window (SNMP v1 or v2c)

System Administrator Guide for VSP E990 and VSP G130, G/F350, G/F370, G/F700, G/F900

Version
88-06-0x
Audience
anonymous
Part Number
MK-97HM85028-08

This window appears when you click Add on the SNMP tab of the Set Up Alert Notifications window if the SNMP protocol version is SNMP v1 or SNMP v2c.



Item

Description

Community

Specify the community to which SNMP traps are reported.

  • To select an existing community from a pull down menu, clear New.
  • To create a community, select New, and then enter a name.

    You can enter up to 180 alphanumeric characters excluding the following symbols:

    \ , / ; : * ? " < > | & % ^ '

    Do not enter space characters at the beginning or the end of the value.

Send Trap to
Specify the IP address to which SNMP traps are reported.
  • To select an existing IP address from a pull down menu, clear New.
  • To add an IP address, select New, and then enter an address.
  • IPv4: Enter a valid IPv4 address in the format XXX.XXX.XXX.XXX (where XXX is a number from 0 to 255)
  • IPv6: Enter a valid IPv6 address in the format YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY:YYYY: (where YYYY is a hexadecimal number from 0 to FFFF). You can also use an IPv6 address in abbreviated format.
  • Minus symbol: Removes the IP address in that row.
  • Add IP Address: Adds an IP address. You can add up to 32 IP addresses.