Change Sending Trap Setting window (SNMP v3)

System Administrator Guide for VSP 5000 Series

Version

90-09-2x

Audience

anonymous

Part Number

MK-98RD9009-16

Use the Change Sending Trap Setting window to set up an alert notification when using SNMP v3.

This window appears when you click Change on the SNMP tab of the Set Up Alert Notifications window if the SNMP protocol version is SNMP v3.

Item	Description
Send Trap to	Specify the IP address to which SNMP traps are reported. IPv4: Enter a valid IPv4 address in the format `XXX`.`XXX`.`XXX`.XXX (where `XXX` is a number from 0 to 255) IPv6: Enter a valid IPv6 address in the format `YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`:`YYYY`: (where `YYYY` is a hexadecimal number from 0 to FFFF). You can also use an IPv6 address in abbreviated format.
User Name	Enter the user name to be used for reporting SNMP traps. You can enter up to 32 alphanumeric characters, excluding the following symbols: \ , / ; : * ? " < > \| & % ^ Note: Do not include space characters at the beginning or end.
Authentication	Select whether to perform the authentication. Enable: Authentication is performed. Disable: Authentication is not performed. Authentication and encryption information is displayed only if authentication is enabled.
Authentication - Protocol	If authentication is enabled, select either of the following authentication methods: SHA-1 or MD5 (SVP firmware version 90-08-21/`xx` or later) SHA or MD5 (SVP firmware version earlier than 90-08-21/`xx`)
Authentication - Password	If authentication is enabled, enter a password. The password must be 8 to 180 alphanumeric characters and can include the following symbols: \ , / ; : * ? " < > \| & % ^ Note: Do not include space characters at the beginning or end.
Encryption	Select whether to perform the encryption Enable: Encryption is performed. Disable: Encryption is not performed. Encryption information is displayed only if encryption is enabled.
Encryption - Protocol	If encryption is enabled, select either of the following encryption methods: AES-128 or DES (SVP firmware version 90-08-21/`xx` or later) AES or DES (SVP firmware version earlier than 90-08-21/`xx`)
Encryption - Key	If encryption is enabled, enter a key. The key must be at least 8 alphanumeric characters, including the following symbols: \ , / ; : * ? " < > \| & % ^ Note: Do not include space characters at the beginning or end.
Encryption - Re-enter Key	Re-enter the same key.