Configuring the settings for session idle timeouts

Ops Center Installation and Configuration Guide
Version
11.0.x
Audience
anonymous
Part Number
MK-99OPS001-23
After you log in to the Hitachi Ops Center Portal by using the single sign-on functionality of Common Services, if a specific amount of time elapses with no activity in the window, the session times out.

For the idle timeout settings, you can configure the following two settings:

  • Idle timeout

    Specify the amount of time that can elapse with no activity in the window before a timeout occurs. The default is 20 minutes.

  • Auto refresh

    Specify whether a timeout occurs if the idle timeout time elapses with no operation performed, for a window that automatically refreshes. By default, a timeout does not occur.

    These settings apply to the following products: Automator, Analyzer, and Analyzer viewpoint.

You can configure the idle timeout settings by using the Hitachi Ops Center Portal. The settings will apply to each Hitachi Ops Center product within a few minutes.

Note:
  • The idle timeout settings apply to Common Services and each Hitachi Ops Center product whose version is 10.9.0 or later (7.6.0 or later in the case of Protector). For Hitachi Ops Center products of a version earlier than 10.9.0 (earlier than 7.6.0 in the case of Protector), timeouts might not occur.

  • Actual session timeouts might differ by a few minutes from the configured idle timeout time.