When installing Ops Center Automator in a cluster configuration, you must follow a series of steps to prepare both the active node and the standby nodes.
The following shows the general workflow for setting a up cluster environment:
When installing Ops Center Automator to a cluster environment for the first time, make sure that every node in the cluster has the same disk configuration, and all Common Component products are installed in the same location (including drive letter, path, and so on) on each node.
If you are upgrading your software, ensure that you back up the existing system configuration and data using the backupsystem command.
Note: When upgrading
Ops Center Automator that is already installed in a cluster configuration, you must disable the resource script before running the upgrade installation.