Recovering from power stand-by

NAS Platform Series 5000 Hardware Reference

Part Number

When the server is in a power standby state, the power supplies are powered and the PSU LEDs are lit, but the Power Status LED on the rear panel is not.

The server enters a stand-by power state due to any the following conditions:
  • The shutdown --powerdown command has been issued.
  • The PWR button is pressed when the server is running.
  • The server has shut down automatically due to an over-temperature condition.
You can restore the server to its normal power state by either of the following methods:
  • Press the PWR button.
  • Remove the power cables from both PSUs, wait for 10 seconds, then reconnect the cables to the PSUs.