Perform the steps below to change the eth0 settings on the SMU
- Switch to the browser session on the External SMU.
- Navigate to Home > SMU Administration > Network Configuration.
- Change the IP address on eth0 to the desired value.
- Change the Subnet mask on eth0 to the desired value.
- Change the Gateway on eth0 to the desired value.
- Click <Apply>.
- The SMU will now reboot to make the appropriate network configuration changes.
- When the SMU has rebooted, open a browser session to the SMU.
- Log in as admin; Enter the current password.
Verify that the SMU can contact the nodes across the network connections
- Open a PUTTy session to the SMU.
- Log in as manager; Enter the manager password when prompted.
- Ping each of the Node's new IP addresses from the SMU.