To access an available iSCSI Target:
Note: The appearance of the screens depends on the operating system version.
- Navigate to the iSCSI Initiator Properties on your Windows system.
- Open the iSCSI Initiator Properties dialog.
- Select the Targets tab.
- Select a target.
-
Click
Log On to display the Log On to Target dialog.
Note: Each logon starts an iSCSI session, and a maximum of 32 iSCSI sessions are allowed per Target.
- Click OK to log on to the target.
-
If authentication is enabled on the target, click
Advanced... to open the
General tab in the
Advanced Settings dialog.
- Select the CHAP logon information checkbox and enter the Target secret (the password configured when the iSCSI target was created).
- If mutual authentication has been configured, select the Perform mutual authentication checkbox.
- Click OK to save the settings and return to the return to the Log On to Target dialog.
-
Optionally, configure multi-pathing.
If multi-pathing is supported by the Microsoft iSCSI initiator, and you want to use multiple paths to the target, fill the Enable multi-path checkbox.
To create multiple paths to the target, you must later start another session to the target.
-
Establish the connection.
Click OK to establish the connection to the selected target.