The SVP comes with a front bezel that is attached to the SVP and rack using rail brackets.
Confirm the SVP is secure in the rack.
-
Attach lock to right bracket using a screw, and then set aside.
- With the SVP at the installation position, attach a washer and screw on each side of the rack leaving it unscrewed enough to attach the brackets.
-
Slide the left and right bracket into position behind the washers.
-
Attach the extrusion behind each bracket and into each bottom slot. Ensure
brackets are aligned vertically before tightening the screws.
-
Align the front and back rails on each side of the rack and install two screws
on each side.
-
Align the left side of the bezel at approximately a 25° angle and snap the
top-right corner of the bezel into place.