-
Concatenate the LINKLIB load library HDSRLNKT to LNKLST.
You can concatenate by using either of the following methods:
-
Static method: Specify the LINKLIB load library HDSRLNKT in the PROGxx parmlib member as a dataset concatenated to LNKLST.
To enable concatenation, you must perform an IPL again.
-
Dynamic method: Use the SETPROG LNKLST command to concatenate the LINKLIB load library HDSRLNKT to the LNKLST.
If you cannot perform an IPL because the system is running, use this method to concatenate the load library. However, because performing an IPL will invalidate concatenation, modify parmlib as defined for the static method, above so the change will continue across an IPL.
-
-
Register the LINKLIB load library HDSRLNKT for APF authorization.
You can register by using either of the following methods:
-
Static method: Add the LINKLIB load library HDSRLNKT to the PROGxx parmlib member as a dataset to be authorized as APF.
To enable registration, you must perform an IPL again.
-
Dynamic method: Use the SETPROG APF,ADD command to register the load library as APF authentication.
If you cannot perform an IPL because the system is running, use this method to perform registration. However, because performing an IPL will invalidate registration, modify parmlib as described above for the static method so the change will be available across an IPL.
Tip:LNKLST has APF authorization by default, so you do not have to perform step 2, if the LINKLIB load library HDSRLNKT was concatenated with LNKLST in step 1. Note that there are exceptions to this rule. For details about APF authorization related to LNKLST, see the IBM manual MVS Initialization and Tuning Reference.
-
Reference information
For details on the SETPROG command, see the IBM manual MVS System Commands.
-
Registering the RSINSCHK command and the RSQRYSMS command in TSO/E for authentication