This subsection describes how to start the system logger service.
To start the system logger service, activate the subsystem (system logger address space). If the subsystem is not active, an error will occur in the connection request macro (IXGCONN).
Use either of the following methods to activate the subsystem.
-
Add SUBSYS SUBNAME(LOGR) INITRTN(IXGSSINT) to the IEFSSNxx parmlib member.
To activate the subsystem with this method, you must perform an IPL again.
-
Use the SETSSI ADD,SUBNAME=LOGR,INITRTN=IXGSSINT command to dynamically add the subsystem.
Tip:
To stop the system logger service, execute the FORCE IXGLOGR,ARM command. To restart the system logger service that was stopped by the FORCE IXGLOGR,ARM command, use the S IXGLOGRS command.