Checking the updated settings

This chapter describes steps involved in how to check the updated settings by using the dlnkmgr command's set operation after settings have been changed.

Performing this operation displays the HDLM function settings after settings have been changed. The following is an example of executing the command:

# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version                   : x.x.x-xx
Service Pack Version           :
Load Balance                   : on(extended lio)
Support Cluster                :
Elog Level                     : 2
Elog File Size(KB)             : 1000
Number Of Elog Files           : 5
Trace Level                    : 1
Trace File Size(KB)            : 2000
Number Of Trace Files          : 10
Path Health Checking           : on(10)
Auto Failback                  : on(10)
Reservation Status             : 
Intermittent Error Monitor     : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name = view, completion time = yyyy/mm/dd hh:mm:ss
#

After you have set up the collection of audit log data, use the following command to make sure that the setting has been specified correctly:

# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log                      : on(6)
Audit Log Category             : all
Audit Log Facility             : local0
KAPL01001-I The HDLM command completed normally. Operation name = view, completion time = yyyy/mm/dd  hh:mm:ss
#