Use the following procedure to change the IP addresses and communities for trap notification for SNMP versions v1 and v2c.
You must have the Storage Administrator (Initial Configuration) role to perform this task.
- In the maintenance utility, click Administration > Alert Notifications.
- In the Alert Notifications window, click Set Up.
- In the Set Up Alert Notifications window, select the SNMP tab.
- Under SNMP Agent, click Enable.
- Under SNMP Version, select v1 or v2c.
- Under Registered Sending Trap Settings, select a trap setting that you want to change, and then click Change.
-
In the
Change Sending Trap Setting window, under
Community, enter a community name.
You can enter up to 180 letters, numbers, and symbols, except the following:
" \ ; : , * ? < > | / ^ & % '
Do not use a space at the beginning or end of the name.
-
Under
Send Trap To, complete the following:
- If you enter a new IP address, click Add IP Address to add input fields. Check the New check box, and then select IPv4 or IPv6 for the version of the IP address. Enter an IP address.
- If you use an existing IP address, uncheck the New check box. Select an existing IP address from the pull-down menu.
- If you delete an IP address from Send Trap to, click the - button to delete the IP address.
-
Click
OK.
The IP address and community that you entered are changed to the Registered Sending Trap Settings table.
- Confirm the settings, and then click Apply.