Adding trap notification for SNMP v3

System Administrator Guide for VSP One Block 85
Version
A0-05-4x
Audience
anonymous
Part Number
MK-26VSP1B030-03
ft:lastEdition
2026-06-22
Use the following procedure to add IP addresses and users to trap notification for SNMP v3.
  1. In the maintenance utility, click Administration > Alert Notifications.
  2. In the Alert Notifications window, click Set Up.
  3. In the Set Up Alert Notifications window, select the SNMP tab.
  4. Under SNMP Agent, click Enable.
  5. Under SNMP Version, select v3.
  6. Under Registered Sending Trap Settings, click Add.
  7. In the Add Sending Trap Setting window, under Send Trap To, select IPv4 or IPv6 and enter an IP address.
    Note: Any IP address that has all values set to zero (0) cannot be specified for IPv4 and IPv6. The IPv6 address is specified by entering eight hexadecimal numbers that are separated by colons (:) using a maximum of 4 digits from zero (0) to FFFF, inclusive. The default form of the IPv6 address can be specified.
  8. Under User Name, enter a user name.
    Note: If you use a user name that has already been specified for Sending Trap Setting or Request Authentication Setting, specify the same settings for the following options that were specified for that name. Otherwise, SNMP traps might not be sent correctly.
    • Authentication
    • Authentication - Protocol
    • Authentication - Password
    • Encryption
    • Encryption - Protocol
    • Encryption - Key

    You can enter up to 32 letters, numbers, and symbols, except the following: 

    " \ ; : , * ? < > | / ^ & %

    Do not use a space at the beginning or end of the name.

  9. Under Authentication, select whether to Enable or Disable authentication.
    If you select Enable, complete the following steps:
    1. For Protocol, select an authentication type.
    2. For Password, enter a password.
    Note: The protocols (authentication types) you can select differ depending on the security mode settings as shown in the following table. Only the selectable protocols are displayed.
    Security mode Protocol (Authentication type)
    SHA SHA-256 SHA-384
    FIPS Yes Yes Yes
    CNSA1.0 No No Yes
  10. Under Encryption, select whether to Enable or Disable encryption.
    If you select Enable, complete the following steps:
    1. For Protocol, select an encryption type.
    2. For Key, enter a key.
    3. For Re-enter Key, enter the same key for confirmation.
    Note: The protocols (encryption types) you can select differ depending on the security mode settings as shown in the following table. Only the selectable protocols are displayed.
    Security mode Protocol (Encryption type)
    DES AES AES-256
    FIPS Yes Yes Yes
    CNSA1.0 No No Yes
  11. Click OK.
    The IP address and user you entered are added to the Registered Sending Trap Settings table.
  12. Confirm the settings, and then click Apply.