Launch the maintenance utility

System Administrator Guide for VSP One Block 85
Version
A0-05-4x
Audience
anonymous
Part Number
MK-26VSP1B030-03
ft:lastEdition
2026-06-22

There are two ways to launch the maintenance utility:

  • Log in to VSP One Block Administrator, and then launch the maintenance utility from there.
  • Log in directly to the embedded maintenance utility software.
Note: Make sure that AMC-0 or AMC-1 is connected with the management LAN. If both AMC-0 and AMC-1 are connected, remove one of them from the management LAN. (SIM 7d13xx is issued by this operation.) Confirm that the ESM Status lamp on the removed AMC has changed to ESM Ready, and then proceed to the next step. (It can take up to approximately 30 minutes for the ESM Status lamp to change to ESM Ready.)

Log in to VSP One Block Administrator and launch the maintenance utility

  1. On the management PC, open a web browser and enter the IP address of the management port of the storage system:
    <http(s)>://<IP address>/

    Use the service IP address, or use the static IP address of the AMC (AMC-0 or AMC-1) with the ESM in the Active state.

  2. On the VSP One Block Administrator main window, enter your user name and password and then click Log in.

    If you are the first person to log in to the storage system, enter the user name and password for the maintenance user:

    • User name: maintenance
    • Password: delivered with the storage system
    Note: If login fails and a message appears requesting you to change your password, change the password in the maintenance utility, and then try logging in to VSP One Block Administrator again.
  3. In the VSP One Block Administrator main window, click the tile icon (top right, Management Tools), and then click Maintenance Utility.

    The maintenance utility opens in a separate browser tab.

Log in directly to the maintenance utility

  1. On the management PC, open a web browser and enter the IP address of the management port of the storage system followed by MaintenanceUtility:
    <http(s)>://<IP address>/MaintenanceUtility/

    Use the service IP address, or use the static IP address of the AMC (AMC-0 or AMC-1) with the ESM in the Active state.

  2. In the maintenance utility login window, enter your user name and password and then click Login.

    If you are the first person to log in to the storage system, enter the user name and password for the maintenance user:

    • User name: maintenance
    • Password: delivered with the storage system
    Note: If a message appears requesting you to change your password, change the password in the maintenance utility, log out, and then log in again.