To identify the nodes in the HCP VM system:
- From the HCP 9.1.0 Configuration menu, enter 3 to run the HCP Setup wizard.
- In response to the confirming prompt, enter y or yes to confirm your entry or n or no to try again.
The HCP Setup wizard New Install Menu appears.
HCP Setup: New Install Menu ============================================= [1] HCP Nodes [r] Restore Default Configuration [v] Review Current Configuration [x] Install a New HCP System with This Configuration [w] Exit/Write out Configuration File [q] Return to Configuration Menu Enter your choice. [Default: 1]:
- Enter 1 to identify the nodes in the HCP system. The HCP Nodes appears.
HCP Nodes Menu ============================================= [1] Storage Node Back-end IP Addresses [b] Go Back to the Previous Menu [q] Return to the Configuration Menu Enter your choice. [Default: 1]:
- From the HCP Nodes Menu, enter 1 to identify the storage nodes in the HCP system. Use the back-end IP address to identify each node.
Tip: If you chose to enter the node IP addresses as literal values, enter the IP address of the lowest-numbered node first. For subsequent IP addresses, HCP Setup gives a default value that is one greater than the previous IP address that you entered.
- From the HCP Nodes Menu, enter b to return to the New Install Menu.
The New Install Menu now includes additional options for configuring the HCP system.
HCP Setup: New Install Menu ============================================= [1] HCP Nodes [2] Distributor/OEM Key Access (Arizona) [3] Networking Settings [4] DNS Settings [5] Time Settings [6] Internal Configuration Settings [7] Security and Encryption Settings [c] Load HCP Configuration File [r] Restore Default Configuration [q] Review Current Configuration [x] Install a New HCP System with This Configuration [w] Exit/Write out Configuration File [q] Return to Configuration Menu Enter your choice. [Default: 2]: